If the water is flowing faster it spends less time in the heater and so it can t get as hot.
Truma water heater problems.
If the relays are faulty this can reduce the power of the heater.
The unit has worked without further problems following replacement of the fuse.
Perhaps the truma guys will chime in here.
On taking a closer look i noticed that water was dripping from the hot water outlet connection.
My model has settings at 500w 1kw and 2kw.
Maximum of 65 psi 4 5 bar.
Water escaping at pressure relief.
They are known to fail for no apparent reason.
However the aqua go has a small tank in it which will likely reduce temperature swings compared to other tankless water heaters.
Ceramic slow blow fuse fitted on the control pcb.
Search for other brands on my channel.
If you are lacking heat by searching the web i found that there are several problems that seem to afflict these heaters 1 relays not working.
Water pressure in water system too.
If the water system is connected to a cen.
Tral water supply higher than 65 psi 4 5 bar rural or urban connection a pressure reducer must be used.
Truma water heater problems.
I first noticed the problem when the carpet near the boiler door seemed to be wet.
Adjust the water pump pressure to a.
The truma aquago basic does not have frost protection and should not be used or filled with water when there is a danger of freezing.
Most truma hot water systems have a small 10 amp.
I have recently had one fail on a truma system that was less than 9 months old.