Toilet Water Shut Off Valve Leaking Australia

How to replace a toilet seal in 16 steps.

Toilet water shut off valve leaking australia.

Do not remove the valve just tighten the packing nut. Shut off water supply to the house at the main. Disassemble the shutoff valve. Step 3 remove the nut.

Turn on all the faucets and flush all the toilets associated with the main shutoff valve to empty the pipes of water. The chain hook must be removed and a new flapper set into its place. Let water drain from open faucets. Open all the cold water faucets start with the highest faucet 2nd or 3rd floor and work to your lowest faucet first or basement floor.

You can do this by turning the valve by the toilet base clockwise. Place the small container underneath the valve in case some water leaks into it while you do the repairs. If the main valve is the one that s dripping you ll need to turn off the street side valve before replacing it. Step 3 remove the screw in the center of the shutoff valve handle using a screwdriver.

If the street side valve needs replacement as well you ll have to call your water utility company to shut off the water supply at the curb. Then follow our step by step instructions on our article. Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges. If you still can t stop the dripping you ll have to turn off the main valve and replace the drippy one completely.

To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position. Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut. Use light steady pressure so you don t damage the water lines. Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.

Flush all the toilets in the home. Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work. Wait approximately 20 to 30 minutes. Water will stop flowing into the tank.

Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks. When you re ready to get started shut off the water. It is located inside the toilet tank at the bottom. The small plastic tub will catch the water from the pipes to avoid spillage.

Wrap cloth or masking tape on the plier s jaws to protect the nut s finish.