Slide your clean end fitting onto the.
Soldering cable ends bicycle.
A better way to terminate your bike s shifter and brake cables.
The way i was taught didn t involve heating the cable at all.
You don t want to catch.
Saab2k when i build a bike the cable ends are done the traditional method eg fit a crimp to fit and pinched once in the middle with a dull set of dikes.
I m running my soldering iron at it s max of 850 degrees f mostly because i m impatient but you should be fine using a much lower.
Keep the cable clean if you ve touched the cable with oily fingers or put in someplace where it might pick up oil or.
When i travel and have to.
Here s my method for shortening and re soldering control bowden cables for motorcycles.
I just dip the cable in the flux then press the solder against the hot soldering gun until a little drop melts on there then press the melted solder against the fluxed cable end and it sucks the solder right up with a delightful sizzle.